User manual

Page - 64/89 AE9ZP0BD - DUALAC2/&HP/POWER - User Manual
After changing a parameter, press ENTER to confirm data when requested by
the message on the console. Parameters modified and optimized on one unit can
be stored by the Zapi Pc-console (SAVE) and then downloaded (RESTORE) to
another controller, thus allowing fast and standardized settings (see Pc-console
manual for details).
Flow Chart showing how to make Parameter changes using Digital Console fitted
with Eprom CK ULTRA.
1) Opening Zapi Display.
DUALAC2 ZAPI V0.0
48V 350A 00000
2) Press ENTER to go into the General Menu.
' % '
' ' '
3) The Display will show:
MAIN MENU
PARAMETER CHANGE
4) Press ENTER to go into the Parameter Change
facility.
' % '
' ' '
5) The Display will show the first parameter.
ACCELER. DELAY
LEVEL = 4
6) Press either ROLL UP and ROLL DOWN to
display the next parameter.
% ' '
% ' '
7) The names of the Parameters appear on the
Display.
RELEASE BRAKING
LEVEL = 5
8) When the desired Parameter appears, the
Display will show a Level Number that will be
Between 0 and 9. Press either PARAM (Top Right)
or SET (Bottom Right)buttons to change the Level
value.
' ' %
' ' %
9) The Display will show the New Level.
RELEASE BRAKING
LEVEL = 6
10) When you are satisfied with the results of the
changes you have made, press OUT.
' ' '
' % '
11) The Display asks “ARE YOU SURE?”.
ARE YOU SURE?
YES=ENTER NO=OUT
12) Press ENTER to accept the changes, or press
OUT if you do not wish to accept the changes and
wish to make further modifications to the
parameters.
' % '
' ' '
' ' '
' % '
13) The Display will show:
MAIN MENU
PARAMETER CHANGE