User manual

Page - 66/89 AE9ZP0BD - DUALAC2/&HP/POWER - User Manual
current rms (A) current rms (A)
temperature (°C) temperature (°C)
temperature #1(°C) voltage booster (%)
temperature #2(°C) battery voltage (V)
accelerator (V) seat switch (ON/OFF)
steer angle (°) forward switch (ON/OFF)
int. wheel cutback (%) backward switch (ON/OFF)
forward switch (ON/OFF) enable switch (ON/OFF)
backward switch (ON/OFF) lifting control (V)
enable switch (ON/OFF) lifting switch (ON/OFF)
seat switch (ON/OFF) 1st speed switch (ON/OFF)
backing switch (ON/OFF) 2nd speed switch (ON/OFF)
cutback switch (ON/OFF) 3rd speed switch (ON/OFF)
brake switch (ON/OFF) 4th speed switch (ON/OFF)
exclusive hydro (ON/OFF) 5th speed switch (ON/OFF)
brakepedal pot. (%) pump current (A)
handbrake (ON/OFF) pump voltage (V)
voltage booster (%) pump temperature (°C)
battery voltage (V)
battery charge (%)
hours-meter
- Save function (for storing data) --> only with Pc-console.
- Restore function (for downloading parameters to another controller) --> only
with Pc-console.
- Display of the last 5 alarms including hour-meter value and temperature at
the moment of the alarm.
- Accelerator range programming.
Records the minimum and maximum useful accelerator stroke values for
both direction of running.
- See the console manual for a detailed description of function and
parameters.
8.7 Sequence for Ac Traction Inverter setting
When the "Key Switch" is closed, if no alarms or errors are present, the Console
Display will be showing the Standard Zapi Opening Display.
If the controller is not configured to your requirements, follow the sequence
detailed here following. Remember to re-cycle the Key Switch if you make any
changes to the inverter’s configuration.
1) Select the Options required. See Chapter 8.4.
2) Select and set the Battery Voltage. See Chapter 8.4.
3) Confirm correct installation of all wires. Use the Console’s TESTER function
to assist.
4) Perform the accelerator signal acquisition procedure using the Console
“PROGRAM VACC”. Procedure is detailed on Chapter 9.3.
5) Perform the steering potentiometer signal acquisition, using the parameters
in "Adjustment" menu (see Chapter 8.4).
Remember: turning the wheel to right direction, voltage has to increase.
6) Set the maximum steering angles, right and left direction; use the parameters
in "Adjustments" menu (see Chapter 8.4).
7) Set the "MAXIMUM CURRENT” Current, using the table on Chapter 8.5.1.
8) Set the Acceleration Delay requirements for the machine. Test the parameter
setting in both directions.