User manual

Page - 72/89 AE9ZP0BD - DUALAC2/&HP/POWER - User Manual

Flow Chart showing how to use the TESTER function of the Digital Console.

1) Opening Zapi Display.

DUALAC2 ZAPI V0.0

48V 350A 00000

2) Press ENTER to go into the General menu.

' % '

' ' '

3) The Display will show:

MAIN MENU

PARAMETER CHANGE

4) Press ROLL UP or ROLL DOWN button until

TESTER MENU appear on the display.

% ' '

5) The Display shows:

MAIN MENU

TESTER

6) Press ENTER to go into the TESTER function.

' % '

' ' '

7) The first variable to be tested is shown on the

Display.

MOTOR VOLTAGE

8) Press either ROLL UP or ROLL DOWN buttons

until your desired variable for measurement

appears on the Display.

% ' '

9) When you have finished, Press OUT.

' ' '

' % '

10) The Display shows:

FREQUENCY

11) Press OUT again and return to Opening Zapi

Display.

' ' '

' % '

MAIN MENU

TESTER

Remember it is not possible to make any changes using TESTER. All you

can do is measure as if you were using a pre-connected multimeter.