User's Manual

RW 220 Vehicle Cradle Installation Guide

continued on next page

• Turn the vehicle’s power source on, and verify that the

power indicator light and the charger light on the charger

module are lit.

4. Turn the printer on and print a conﬁguration label to verify

that the printer is functioning properly.

Refer to the RW Series User’s Guide for instructions on printing a conﬁgura-

tion label.

5. If you will be communicating to a data terminal with a data

I/O cable, turn the printer off, plug in the data I/O cable and

turn the printer back on.

Removing the Printer

Please refer to Figure 4. Remove the Printer by doing the follow-

ing:

• Turn the Printer off.

• If the Printer is directly connected to a communications ca-

ble, unplug and remove the cable from the Printer.

• If you are using a Zebra Mobile Charger, unplug the charger

Figure 4: Removing the Printer from the Vehicle Cradle

Lift the printer free

of the retaining

pins.

Lift the Latch

Button to

release the

Printer.

Rotate the Printer out

of the Cradle.