Owner`s manual

Inslalla#on
The TV has a spec_ai signal output capability which allows you
to hook up a second TV or monitor.
Connect the second TV or monitor to the TV' AV OUTPUT. See
rite Operating Manual of the _cond TV or monitor for further
detai_s regarding that device's input settings
NOTE: * Component RGB-PCiDTV 480pi720pi1080i input
sources cannot be used for Monitor out,
- This TV provides Plug and Play capability; meaning that the PC adjusts automaticai[y to its settings, The TV sends configuration
inform_ion (EDtD) to the PC using the Video Electronics Standard Association (VESA) Display Data Channel (DDC) protocol.
How to connect
1. To get the best picture qua_ity_ adjust the PC graphics card to a
640x480, 60Hz,
2. Use the TWs RGB iNPUT or DW (Digita_ Visua_ Ir4erface) INPUT
port for video connections depending on your PC connector.
If the graphic card on the PC does not o_put anatog and digital
RGB simultan_usly connect only one of both RGB iNPUT or DVI
INPUT to dispray the PC on the TV.
If the graphic card on the PC does output analog and dig_a] RGB
simuffaneous[y, set the TV to either RGB or DW: (the other mode
is set to Plug and Piny automatically by the TV,)
3. Then_ make the corres_nding audio connections ff using a
sound card, adjust the PC sound as required,
How to use
1. Turn on the PC and the TV.
2 Turn on the display by pressing the POWER button on the TV's
remote control
3, Use the INPUT SELECT button on the remote control to se[eot
RGB or DVI,
4_ Check the image on your TV. There may be noise ass_iated with
the resolution, verticat pa_ern, cor_rast or brightness in PC mode,
ff noise is present, change the PC mode to another resolution
change the refresh rate to another rate or adjust ti_e brightness
and contrast on the menu until the picture is dear, if the refresh
rate of the PC graphic card can not be changed, change the PC
graphic card or consult the manufacturer of the PC graphic card
NOTES: • Depending on the graphics card DOS mode may not
work if you use a DVi-I cabie.
• Avoid keeping a fixed image on the TV's screen for a long
period of time The fixed image may become permanently
imprinted on the screen Use the Orbiter screen saver
when _ssible.
• The synchronization input form for Horizontal and Vertical
frequendes is separate,
® • 000 O@O @ _ I
, ' i ....
Owners Manual 15