Owner`s manual

Warning
f
CAUTION
WA R N IN G"
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equi_atera_ triangle, is intended to aierf the user to
the presence of uninsu_ated "dangerous voffage _ wffhin the product's enclosure that may be of suffi=
cier_ magnffude to constit_e a dsk of electnc shock to persons.
The exclamation point within an equiiaterai tdangie is intended to aJerf the user to the presence of
importat_t operating and maintenance (servicing) instructions in the literature accompanying the appli-
ance.
WA R N IN G
TO PREVENT FiRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE
NOTE TO CABLE/TV INSTALLER:
This reminder is provided to call the CATV system instaJ_er's _ention to Article 820-40 of the National Electric
Code (U.S.A.) The code provides gui_lines for proper grounding _d, in particular, specifies that the cable
ground shale be connected to the grounding system of the building as dose to the point of the cable entry as prac-
tical
REGULATORY INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digffat device, pursuant to Part
15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in
a residential installation T]_is equipment generates, uses and can radiate radio frequency energy and_ if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications
However, there is no guarantee that interference will not occur in a particular instatl_ion ff this equipment does
cause harmfut interference to radio or television reception which can be determined by turning the equipment off
and on the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna,
- _ncrease the separation between the equipment and receiver,
- Connect the equipment into an out_et on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio!TV technician for help,
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to oper_e the equipment_
CAUTION:
Do not attempt to modify this product in any way wffhout written a_horization from Zenith Electronics
Corporation, Una_horized modification could void the user's authority to operate this product,
COMPLIANCE:
The responsible p_y for this product's compliance is:
Zenith Electronics Corporation
2000 Mil]brook Drive
Lincolnshire, H 60069_ USA
Phone: [phone]
2 Plasma TV