SDS
SAFETY DATA SHEET
ZEP INSTANT HAND SANITIZER GEL 70% W/PUMP 4-1GL
Version 1.3
Revision Date 01/22/2021
Print Date 02/23/2021
3 / 11
In the workplace, if a significant exposure or spill occurs on
the skin, immediately wash off with plenty of water.
In case of eye contact
:
Remove contact lenses.
Protect unharmed eye.
If in eyes, rinse with water for 15 minutes.
Keep eye wide open while rinsing.
If eye irritation persists, consult a specialist.
If swallowed
:
Keep respiratory tract clear.
DO NOT induce vomiting unless directed to do so by a
physician or poison control center.
Never give anything by mouth to an unconscious person.
If symptoms persist, call a physician.
Most important symptoms
and effects, both acute and
delayed
:
Effects are immediate and delayed.
Symptoms may include irritation, redness, pain, and rash.
Causes serious eye irritation.
Review section 2 of SDS to see all potential hazards.
Notes to physician
:
Treat symptomatically. Symptoms may be delayed.
SECTION 5. FIREFIGHTING MEASURES
Suitable extinguishing media
:
Alcohol-resistant foam
Carbon dioxide (CO2)
Dry chemical
Water spray jet
Unsuitable extinguishing
media
:
High volume water jet
Specific hazards during
firefighting
:
Do not allow run-off from fire fighting to enter drains or water
courses.
Hazardous combustion
products
:
Carbon dioxide (CO2)
Carbon monoxide
Smoke
Specific extinguishing
methods
:
Use extinguishing measures that are appropriate to local
circumstances and the surrounding environment.
Further information
:
Collect contaminated fire extinguishing water separately. This
must not be discharged into drains.
Fire residues and contaminated fire extinguishing water must
be disposed of in accordance with local regulations.
For safety reasons in case of fire, cans should be stored
separately in closed containments.
Use a water spray to cool fully closed containers.
Special protective equipment
for firefighters
:
Wear self-contained breathing apparatus for firefighting if
necessary.
SECTION 6. ACCIDENTAL RELEASE MEASURES
Personal precautions,
protective equipment and
emergency procedures
:
Material can create slippery conditions.
Use non-slip safety shoes in areas where spills or leaks can
occur.
Refer to protective measures listed in sections 7 and 8.
Beware of vapours accumulating to form explosive
concentrations. Vapours can accumulate in low areas.
Environmental precautions
:
Prevent product from entering drains.
Prevent further leakage or spillage if safe to do so.