Hood User Manual

housing using (4) screws. See Fig. 5
6. Insert the 6 pin female molex connector into the
junction box. See Fig. 6A. Secure remote blower
junction box included in the hardware packet to
top of blower housing using (2) screws. See Fig.
6B
7. Feed remote blower wire harness through remote
blower junction box cover and Connect the wires
with those inside the junction box. See Fig. 7
Note: Carry out the power supplly con-
nection in accordance with the natio-
nal electric code, ANSI/NFPA 70-1999.
8.Secure cover to junction box using (2)
screws.
Note1: A cable lock (not included) may
be required by local codes. Please
review local codes for more informa-
tion.
9. Attach 6 pin male molex connectors to 6 pin fe-
male molex connectors inside blower housing.
See Fig. 8
Note2: Check local codes to determine minimum
wire gauge.
See manual included with external and in-
line blower for instructions on installing
the blower.
- 16 -