Use and Care Manual

PRKB24C01AG & PRKB24C01AS-OD Use, Care, and Installation Guide

KEGERATOR &

BEVERAGE COOLER

INDOOR & OUTDOOR

PRESRV™

Installation Instructions

1. With the shuto valve on the regulator turned

o (perpendicular to the tubing), completely

open the hand valve on the CO₂ tank (FIG. L).

2. Turn the pressure adjustment knob until the

desired pressure is shown on the low pressure

guage (FIG. M). We recommend setting the

regulator between 10-12 PSI to start and adjust

later as needed. Turn the knob clockwise to

increase pressure and counterclockwise to

decrease pressure.

NOTE: Other conditions such as altitude or beer

type may require additional adjustments.

3. Open the shuto valve on the regulator so it is

parallel with the tubing (FIG N).

4. The keg coupler is designed with a pressure

relief valve (PRV) as shown in FIG. O. Brieﬂy

pull the ring on the PRV to allow CO₂ gas to

vent. This will permit CO₂ gas to ﬂow through

the regulator and help obtain a more accurate

reading on the low pressure guage.

NOTE: We recommend following up on any

adjustment to the regulator with a brief pull of the

PRV ring to ensure an accurate output reading.

Check for leaks.

FIG. L

Pressure adjustment knob

FIG. M

Calibrating the Regulator

FIG. N

FIG. O