Use and Care Manual

Milano Use, Care, and Installation Guide

MILANO

WALL

CORE

Installation Instructions

Mounting the Hood

At least two installers are required due to the

weight and size of the hood.

CAUTION

1. Measure from range top to hood bottom and

mark line A. (24” minimum from range top).

2. Plum and mark center line.

3. Mark mounting height line B. (18-5/8” from line

A).

4. Mark mounting spread from C/L. (11-1/4”).

5. Fasten (2) #6 x 1-1/2” screws into studs on line B

but do not tighten all the way.

Wood blocking may need to be added behind

the drywall if no studs are present. Wall anchors

may also be used but check local codes for

compliance. Failure to use suitable wall anchors

and screws to hold the weight of the hood could

result in personal injury or damage to cooking

surface or counter.

WARNING

FIG. B

Brackets are

pre-installed

24” min.

11-1/4”

C/L

18-5/8”

Duct Cover

Bracket

6. Remove tape and (2) screws securing electronics mounting bracket to hood. Reposition electronics

mounting bracket as shown in (FIG. A3) and secure to motor housing using the (2) previously

removed screws.

7. Remove (2) screws securing electrical junction box to electronics mounting plate. Remove junction

box. (FIG. A1).

8. Remove the (1) aluminum mesh ﬁlter.