Use and Care Manual

22
Roma Groove Use, Care, and Installation Guide
ROMA GROOVE
WALL
CORE
Features & Controls
How to connect to the Zephyr Bluetooth® Stereo Speakers each subsequent time (after the initial
connection has been made):
1. The speakers can only play audio files from one connected device at a time. If another device was
to connect to the speakers, the currently connected device must disconnect (but not necessarily
unpair) from the speakers first. Disconnecting refers to stopping the connection between the
speakers and the device. Unpairing refers to forgetting its pairing connection, and by unpairing,
the user would have to pair to the speakers again (refer to instructions above).
2. If your device was disconnected but not unpaired from the speakers when previously used, the
user can access the “Paired Devices” (or similar) under Bluetooth® settings and tap on “Zephyr
Bluetooth” to reconnect with the speakers.
3. Open up your personal music or audio files on your connected device and play your desired music
or audio files. The audio will be played from the Bluetooth® speakers.
4. When you’re done playing your personal music or audio files, disconnect from the speakers by
pressing the button. (1) high-pitched beep will be played if disconnecting from the user’s
device, and (4) neutral tone beeps and (1) high-pitched beep will be played if disconnecting from
the speakers.
NOTE: The speakers use Bluetooth® version 4.1. Most Bluetooth® versions are backwards compatible,
meaning older versions can still connect to newer versions; however, some minor features will
not be available, such as syncing the volume between the speakers and device.