Owner`s manual

5
MAINTENANCE
Maintenance For Sunglow
™
Light
Hazardous voltage.
Electrical shock hazard. Before removing
fixture from pool wall, ALWAYS TURN OFF THE POWER
at the breaker. Installation and maintenance of this cir-
cuit, the light, light niche, and any other accessories
attached to this circuit must be performed by a licensed
electrician. The complete electrical system must be
installed, tested, and approved by a licensed electrician
before it is placed in operation.
Risk of cuts, burns, and electrical shock.
Avoid direct impacts on glass lens. Do not install dam-
aged or broken lens.
See Figure 2, Page 6 for Key numbers.
1. Be sure that the power is off. Allow the lamp to cool
before re-lamping.
2. Loosen the captive leader screw (Key. No. 1) from the
top of the fixture trim ring (Key No. 2).
NOTICE: The screw in the trim ring may be recessed.
3. Remove the lamp housing (Key No. 7) and place on
the pool deck.
4. Remove screw from clamp.
5. Using a clean soft lint free cloth, carefully wipe all
sealing surfaces on the lamp housing and lens.
Replace lamp with an equivalent to the original lamp.
6. Replace gasket (Key No. 4). To reassemble the lens
assembly to the lamp housing, reverse the disassembly
process. Be sure that the lamp housing is clean, dry,
and free of all traces of moisture, before sealing the
fixture.
7. Wind the extra cord around the lamp housing and
place the lamp housing back in the niche. Be sure to
align the locator tab at the bottom of the lamp hous-
ing with the notch in the bottom of the niche.
8. Fasten the lamp housing into the niche using the cap-
tive leader screw at the top of the trim ring.