Instruction Manual

1.6 SPECIFICATION
INPUT CHARACTERISTICS: DR1M-6220F
l VOLTAGE: DC -36 V~ -72 V
l INPUT CURRENT: 7.0 A ( RMS ) FOR -48VDC
l INRUSH CURRENT: LESS THAN 10A FOR EACH MODULE
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
OUTPUT
VOLTAGE
MIN. [A] MAX. [A] LOAD LINE
RIPPLE & NOISE
MAX. [P-P]
5V 3.0 25 ± 5% ± 50mV 50mV
12V 2.0 16 ± 5% ±50mV 120mV
-5V 0 0.5 ±10% ± 50mV 150mV
-12V 0 0.5 ±10% ± 50mV 150mV
3.3V 1.0 15 ± 5% ± 50mV 50mV
+5VSB 0.1 2.0 ± 5% ± 50mV 50mV
REMARKS:
1. THE OUTPUT POWER OF 5V & 3.3V MAX: 28A
SPECIFICATION:
l TEMPERATURE RANGE: OPERATING: -10℃ --- 40℃
l STORAGE: -20℃ --- 80℃
l HOLD UP TIME: 1.6 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
l DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
l EFFICIENCY: 68% TYPICAL AT -48VDC FULL LOAD
l POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms
l OVER POWER PROTECTION: 110% ~ 160%
OVER VOLTAGE PROTECTION: +5V à 5.7V ~ 6.6V, 3.3V à 3.9V ~ 4.8V
+12V à 13.0V ~ 15.0V
l SHORT CIRCUIT PROTECTION: +5V, +12V, +3.3V,AUTO-RECOVERED: 5VSB, -5V, -12V
l EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A
l SAFETY: UL 60950, CSA 22.2 NO/ 60950, TÜV EN 60950, CB IEC60950.
l REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE /
ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
l FAULTY ALARM METHODS:LED, BUZZER,TTL SIGNAL.
l HOT-SWAPPABLE/ HOT-PLUGGABLE 1+1 REDUNDANT FUNCTION.
l BALANCE LOAD SHARING DESIGN.
l ISOLATION:BUILT-IN THE POWER MODULE.
l 3.3V / 5V REMOTE SENSING
l COOLING: TWO 40mm DC FAN (ONE IN EACH MODULE)
l DIMENSION: 260 (D) x 180 (W) x 40.5 (H) mm
l CONNECTOR POWER INPUT
A. POSITRONIC: PLB06M CONNECTOR
B. TERMINAL BLOCK