User's Guide

2
2
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1)this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
SAR Information Statement
Your Handheld integrated intelligent terminal is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits for exposure to
radiofrequency (RF) energy set by the Federal Communications Commission of the
U.S. Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are based
on standards that were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of all persons, regardless of
age and health. The exposure standard for wireless mobile phones employs a unit
of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set
by the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting
at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the phone
while operating can be well below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use only the power required to
reach the network. In general, the closer you are to a wireless base station antenna,
the lower the power output. Before a phone model is available for sale to the public,
it must be tested and certified to the FCC that it does not exceed the limit
established by the government adopted requirement for safe exposure. The tests
are performed in positions and locations (e.g., at the ear and worn on the body) as
required by the FCC for each model. The highest SAR value for this model phone
when worn on the body, as described in this user guide, is 0.31 W/Kg (Body-worn
measurements differ among phone models, depending upon available accessories
and FCC requirements). The maximum scaled SAR in hotspot mode is 0.34 W/Kg.
While there may be differences between the SAR levels of various phones and at
various positions, they all meet the government requirement for safe exposure. The
FCC has granted an Equipment Authorization for this model phone with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this model phone is on file with the FCC and can be found under the
Display Grant section of http://www.fcc.gov/ oet/fccid after searching on
FCC ID: 2AGEB-5502 Additional information on Specific Absorption Rates (SAR)
can be found on the Cellular Telecommunications Industry Association (CTIA) web-
site at http://www.wow-com.com. * In the United States and Canada, the SAR limit
for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one
gram of tissue. The standard incorporates a substantial margin of safety to give
additional protection for the public and to account for any variations in
measurements.
The SAR test distance is 10mm.
A. Safety measures for users and non-users
Non-use of the device in certain situations (while driving) and certain places
(airplanes,
hospitals, gas stations and professional garages).
Precautions to be taken by wearers of electronic implants (pacemakers. insulin
pumps.
neurostimulators, etc.) concerning in particular the distance between the device and
the implant (15 centimeters) and the position of the device. During the call on the
side
opposite the implant.
B. Advice for use to reduce the level of consumer exposure to radiation (e.g. Keep
the device away from the human body during night rest or set it to flight mode, etc.).
Recommendation of the use of the device in good reception conditions, to reduce
the
amount of radiation received (especially in an underground car park when travelling
by train
or car...).
Indication of the parameters for good reception (e.g. display of four or five bars on
the screen).
Recommendation to use a hands-free kit and, in this situation. Precautions to be
taken when
Communicating: keep the device away from the abdomen for pregnant women or
from the
lower abdomen for teenagers.
CE Statement
Herby, SHENZHEN ZKC SOFTWARE TECHNOLOGY CO., LTD declares that this
Handheld integrated intelligent terminal，5502 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU. In accordance
with Article 10(2) and Article 10(10), this product allowed to be used in all EU
member states.
Use the Handheld integrated intelligent terminal in the environment with the
temperature between -10℃ and 40℃,
Use careful with the earphone maybe possible excessive sound pressure from
earphones and headphones can cause hearing loss.
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
The product shall only be connected to a USB interface of version USB2.0
SAR: The device complies with RF specifications when the device used at 5mm
from your body. The highest SAR value for this device when worn on the body is
1.39 W/Kg.
Adapter shall be installed near the equipment and shall be easily accessible.
The plug considered as disconnect device of adapter
Adapter Model: GHSOU-090700
Input: AC 100-240V, 50/60Hz,0.4A
Output: DC 9V, 2000mA
ZKC5502
ZKC5502
4G
3G
LTE-TDD(B38/39/40/41)、LTE-FDD(B1/3/5/8)
TD-SCDMA(B34/39)、WCDMA(B1/8)、
EVDO/CDMA(BC0)
TD-SCDMA(B34/39)、WCDMA(B1/8)、
EVDO/CDMA(BC0)
2G
GSM(1800/1900)
WIFI
IEEE802.11b/g
Bluetooth
Bluetooth 4.0
NFC
Optional
Android7.1
1.1 GHz
Android7.1
1.1 GHz
4G
LTE-TDD(B38/39/40/41)、LTE-FDD(B1/3/5/8)
3G
TD-SCDMA(B34/39)、WCDMA(B1/8)、
EVDO/CDMA(BC0)
2G
GSM(1800/1900)
Operation Frequency:
For BT: 2402MHz~2480MHz
For WIFI:
2412MHz~2472MHz (802.11b/802.11g/802.11n(HT20))
2422MHz~2462MHz (802.11n(HT40))
For GPS: 1.57542GHz
For GSM:
E-GSM 900/GPRS 900:
TX: 880MHz~915MHz; RX: 925MHz~960MHz
E-GSM 1800/GPRS 1800:
TX: 1710MHz~1785MHz; RX: 1805MHz~1880MHz
For WCDMA:
UTRA Band I: TX:1920MHz~1980MHz;
RX: 2110MHz~2170MHz
For LTE:
LTE Band 1: (UL)1920MHz~1980MHz,
(DL)2110MHz~2170MHz
LTE Band 3: (UL)1710MHz~1785MHz,
(DL)1805MHz~1880MHz
LTE Band 8: (UL)880MHz~915MHz,
(DL)925MHz~960MHz
LTE Band 38: (UL)2570MHz~2620MHz,
(DL)2570MHz~2620MHz
LTE Band 40: (UL)2300MHz~2400MHz,
(DL)2300MHz~2400MHz
Max Output Power:
For BT: 0.0038W
For WIFI:0.0469W
For GSM900: 1.7458W For GSM1800: 1.2162W
For WCDMA B1: 0.2296W
For LTE B1:0.2393 W For LTE B3:0.1991 W
For LTE B8:0.208 W For LTE B38:0.2286 W
For LTE B40:0.2143 W
Manufacturer：
SHENZHEN ZKC SOFTWARE TECHNOLOGY CO., LTD
Address：1 st Block, Zhongkenuo lndustry Park, Beiqi Road, Xixiang,
Bao'an, Shenzhen, China
E-mail: [e-mail]