Installation Guide

9
INSTALLATION
INSTALLING THE ANTITIP SYSTEM
The chains shipped with the range must be properly secured to studs on the rear wall. The
height of the bracket from the floor must be determined after the range legs have been
adjusted to the desired height and after the range has been leveled.
A child or adult can tip the range and be fatally injured; take care to adjust
the chains if the range is moved. Failure to do so can result in death or
serious injury.
WARNING
Figure 1 Figure 2 Figure 3
Gap distance:
2 1/4" (57 mm)
1. Measure the distance from the floor to where the chains connect on the back of
the appliance.
2. Position the ends of the chains on the wall at the desired height and add an extra 1/8"
(3 mm) to ensure stability. Mark each location with a pencil. The chains must be placed
at 2 1/4" (57 mm) from the back of the range (see Figure 2 above).
3. Pre-drill holes at the marked locations on the wall.
4. Slide the range against the wall, feed Phillips-head screws through each chain, and
tighten using a stub screwdriver or drill with a 90° adapter. Refer to Figure 2 above.
5. Check to see that the chains are connected properly. Then grasp the top rear edge of the
range and carefully attempt to tilt it forward. Verify that the chains are engaged.
6. You may also secure the range with fixed screws on the wall by drilling screws
through the holes in the false exhaust plate at the top rear edge of the range (see
Figures 1 and 3).
NOTE: If your wall is not suitable for installation, chains and/or screws should be fixed to an
appropriate cabinet structure.
Scan to follow along with a video.
Installing the Anti-Tip System