Installation Guide

Table Of Contents

Gas Conversion Procedure

INSTALLATION

STEP 1: PRESSURE REGULATOR

The pressure regulator supplied with the appliance is a convertible type pressure regulator

for use with natural gas at a nominal outlet pressure of 4" W.C.P. (1 kPa) or liquid propane

gas at a nominal outlet pressure of 10" W.C.P. (2.5 kPa) and it is pre-assembled from the

factory to operate with one of these gas pressures as indicated in the labels afﬁxed on the

appliance, package, and instruction booklet.

To convert the regulator for use with other liquid propane gas:

1. Unscrew the front cap of the regulator (as seen below). Inside the cap is a screw. By

hand, remove the screw to reveal a spring. Invert the screw back into the cap with the

spring on top.

2. With the spring sticking out of the cap, reinstall the cap back onto the regulator.

3. Using a manometer, double check pressure is at 10" W.C.P. (2.5 kPa). If you need to

adjust pressure, screw or unscrew the black spacer where the spring is located.

Any issues related to improper propane conversion are NOT covered

under warranty.

WARNING

5/8" (16 mm)

Reverse regulator

screw and spring.

Gas Conversion Procedure

Liquid Propane Gas

Natural Gas