Use and Care Manual

32
Troubleshooting
Possible Cause and/or Remedy
Range is not connected to electrical power. Check
power circuit breaker, wiring, and fuses.
Temperature control knob is rotated too far past
broil position (500°F); preheating indicator will
light intermittently.
Oven is still in self-clean mode. Door latch will
release when a safe temperature is reached.
The circuit is tripped, fuse is blown, or range is not
connected to power.
Gas supply valve is in the “OFF” position or gas
supply is interrupted.
Burner ports are clogged or the unit is not set to
the appropriate gas type. Call a technichian to
repair.
Turn the oven off at the circuit breaker and wait 5
minutes. Turn the breaker back on and the oven
will reset itself.
Check the circuit breaker or fuse box to your
house. Make sure ther is proper electrical power
to your oven.
Replace or reinsert the light bulb if loose or
defective.
Check for obstruction in the oven door. Check to
see if hinge is bent.
There may be soil or build up on the lens cover.
Wipe the lens cover with a clean, dry towel prior
to attempting to remove the lens cover.
Oven Problem
Range does not function
Broil does not work
Door does not open
Igniter does not work
Igniter sparking taut; No flame ignition
Burner ignites but flame is large,
distorted, or yellow
Oven door is locked and will not
release, even after cooling.
Oven is not heating
Oven light is not working properly
Oven light stays on
Cannot remove lens cover on light