Instruction manual

16776 Zodiac G2 manual A5 2/12/08 12:57 PM Page 18

STEP 1: Screw the AD Flow Valve

Connector into the Vacuum

Plate or use Weir Cuff.

DESCRIPTION

1.AD Flow Valve

2. Universal Weir Cuff

3. Hose Protector Mesh

STEP 2:

STEP 3:

Insert the AD Flow Valve

into the AD Flow Valve

Connector.

Connect the AD Flow Valve

into the hose.

AD Flow Valve

Connector

SECTION 1 – INSTALLATION

AD FLOW VALVE

The use of the Zodiac AD Flow Valve is recommended on pools with only one

skimmer box/suction point, or when the filtration system needs to be used but the

pool cleaner does not, such as when people are swimming in the pool. It regulates

the flow of water to the pump through the pool cleaner.As the filter collects

debris, the valve automatically maintains the correct flow to the cleaner. For

installation of the AD Flow Valve see below:

For connection of the AD Flow Connector into a non standard skimmer plate see below:

Waterco Skimmer Box = Screw in the AD Flow Valve connector from the top of the skimmer plate.

Poolrite Skimmer Box = Screw in the AD Flow Valve connector from the bottom of the skimmer plate.

Pool Rite Skimmer Plate Waterco Skimmer Plate

If you do not have a Waterco or Poolrite Skimmer Plate then insert the AD Flow Valve into the Weir Cuff.

The AD Flow Valve comes preset at a factory setting of 2 to obtain maximum pool

cleaning efficiency. If your water flow requires a higher or lower setting, you can

adjust the valve to one of three settings: High (Setting 3), Medium (Setting 2) or

Low (Setting 1).

You will only need to adjust the AD Flow Valve when the following occurs:

PROBLEM SOLUTION

The Zodiac Pool Cleaner is performing too fast

and/or climbing above the level of the water.

Reduce AD Flow Valve to Setting 1

The Zodiac Pool Cleaner is performing slowly

and/or is not climbing the pool walls.

Increase AD Flow Valve to Setting 3