Instruction manual

16776 Zodiac G2 manual A5 2/12/08 12:57 PM Page 9
SECTION 7 – TROUBLESHOOTING GUIDE
Note: If the automatic pool cleaner is climbing the walls excessively, that is an indication
that the flow is too high. Review the installation procedures and ensure the AD Flow Valve
is set at setting #1.
For additional assistance contact our customer service department on 1800 688 552.
PROBLEM SOLUTION
Cleaner stops & starts
Check diaphragm for blockage or damage.
Use P
ool Pulse® to determine proper flow.
Check hoses for leaks.
Cleaner is patterning
Add return diverters or divert return inlets downward.
La
y hose in a straight line in the sun to relax memory.
Confirm proper hose length – add 1 or 2 extra hose sections.
Cleaner isn’t covering
opposite end of pool
Add return diverters or divert return inlets downward.
Use flo
w to move cleaner to opposite end.
Check if sufficient hose and add if necessary.
Cleaner flips over
Use Pool Pulse® to ensure proper flow.
Check s
wivel on cleaner is not jammed with grit or sand.
Cleaner climbs walls
excessiv
ely
Use Pool Pulse® to ensure proper flow.
Ensur
e AD Flow Valve is on setting #1.
Reduce flow to cleaner head.
Cleaner won’t climb
walls
Cleaner may not climb walls of some vinyl lined pools.
Use P
ool Pulse® and raise flow to high setting # 3.
Confirm proper hose length.
Adjust hose weight, so it is further away from the cleaner head.
Cleaner won’t leave
edge or rim of pool
Use Pool Pulse® and lower flow to low setting #1.
Utilise r
eturn flow to move cleaner.
Adjust hose weight.
Note: In cold water of 12 degrees or less, water flow through the cleaner must be
increased to compensate for the reduced flexibility of the hose and diaphragm.
IF ASSISTANCE IS REQUIRED, PLEASE CALL OUR CUSTOMER SERVICE
DEPARTMENT ON 1800 688 552
12