Specifications

Delay effects
DELI Delay 1
Use DECAY (0-10) to adjust the number of cchoes (0 is single).
Use TIME (1-100) to adjust the delay time from 1/100 of a second to
1
second in ten millisecond increments.
Use
BALANCE (0-10) to adjust balance between direct (01 and delay (10).
This is used for echo effects.
REVERB GROUP
(DEL2, REV1, REG'2)
Onefrom this group can be used at a time.
DELZ Delay 2
Use DECAY (0-10) to adjust the number of repeats. (For mono output. the
repeats
will be half the tempo of the stereo repeats.)
Use TIME (1-90) to adjust delay time from 1/100 of a second to 9/10 of a
second in ten millisecond increments.
Use BALANCE (0-10) to adjust the level of the delayed sound.
Delay
2 is a stereo ping-pong delay where the sound echoes from the left to
the right channel (if reproduced
in stereo).
REV1 Reverb 1 (Large Hall]
Use TIME (0-10) to adjust the reverb time.
Use BALANCE (0-10) to adjust the level of the reverb sound.
Reverberation effects are essential for recording and for simulating larger
performance environments. The longest reverb time is
4000ms.
REV2 Reverb 2 (Small Room)
Use TIME (0-50) to adjust the reverb time.
Use BALANCE (0-10) to adjust the level of the reverb sound.
Reverb 1 gives the reverb sound of a concert hall, and Reverb 2 gives
the reverb of
a small room.
The conventional
9002 and 9002PRO have the Reverb 2
configuration. Previously, the harmonics of the guitar amplifier have
been simulated, but the PRO has added an amplifier simulator to the
DIST
PATTERN, so that the amplifier simulator is not included in Reverb 2.
When using the PRO, set DIST on, DEPTH to 0 and PATTERN to 2 if you want
to get the equivalent 9002 setting of Reverb 2 with DIST off.