Specifications

output level of the selected patch. This may be necessary to compensatc:
for changes
in total outpul level rtsulting from your parameter settings.
This gives you control over changes in output level that may occur whcn
vou switch patches tvhile performing.
(1) Use the CURSOR keys to move the effect mark all the way to the right of
SFX or to the left of'COMP. The bars undcr the PEAKIBALANCEIPAT-
TERN
display section ~vill show output level, as will the readout. Or you
can go directly to the output level adjustment mode by pressing the
currently selected PATCH key again.
(2) Ad just the control above t hc PEAK/BALANCG/PATTERN display
section. Output level is adjustable over
n range of 10 to 99. as shown in the
parameter
\.slue readout.
Noise reduction(NR) adjustment
Finally, adjust the noise reduction.
NR lowers the noise during standby.
it can be adjusted and stored for each patch.
(1)NR is adjustable over a range of 0 to 7, as shown in the parameter
value readout, with the data slider on the left. Raise the sliderhalue
until the noise lowers to acceptable level.
Patch storage
To saw >-our cditcd effect patch, follotv these steps.
(1) Press the STORE key once. The selected BANK number and patch LED
will flash to indicate that you are in the storage node.
(2) Usc the RANK and PATCIH keys to select the user bank number and
patch into which you wish to save the sound. (You cannot use a factor?;
preset bank to store edited sounds.)
(31 At [his point you can still press the CANCEL key to cancel the storage
mode and rcturn
to the state that existed before you pressed the STORE
key. If you do not wish to cancel, go on to step
4, below.
(4) Press the STORE key again and the BANK number and patch LED will
stop flashing and remain lit. This confirms storage.
Pre-loaded patch data recall
To load the factory pre-load data into the user banks again,
t~~rn the power off,
then hold the
STORE key down and turn the power on again, All 40 factory
pre-load data will
be loaded into the user patch memories.
N0TE:With this operation, all patches you have stored will be lost.
Necessary patch data should be kept with a memo in the blank patch chart.