User Guide

4-Track Mode
ZOOM H4
47
HINT
If you do not specify a name here, the file created
by bouncing will be automatically assigned a
name using the pattern "BOUNCExx.wav" (where
xx is a number from 00 – 99).
When the underline is shown, change the name
as follows.
(1) Move the jog dial up/down to bring the
underline to the character you want to
change. Then press the jog dial.
The character can now be changed.
(2) Move the jog dial up/down to change the
character.
The following characters are available.
0 – 9
A – Z, a – z
(space) ! # $ % & ' ( ) + , - . ; = @ [ ] ^ _
' { } ˜
(3) Press the jog dial to accept the selected
character.
(4) Repeat steps (1) – (3) as required to
specify the entire name.
(5) Move the jog dial up/down to bring the
underline beyond the left or right edge of
the name string.
The underline disappears and the cursor appears
again. The name change is now complete.
7.
To execute the bounce function,
move the jog dial up/down to bring
the cursor to the OK button. Then
press the jog dial.
While the bounce function is being executed, the
indication "Now Processing" is shown on the
display.
The file created by bouncing is saved in the same
location as the other files recorded for the current
project. To check the bounce result, assign the
file to a track (
→ p. 42).
HINT
If you select the CANCEL button instead of the
OK button, the operation is abandoned and the
unit returns to the top screen of the 4-track mode.
NOTE
If the SD card becomes full during the bounce
operation, the indication "Card Full!" appears, and
the process cannot be completed. Press the jog
dial to close the window, delete files that are no
longer required, and then perform the bounce
operation once more.
Mixer
This section explains the use of the mixer in 4-
track mode.
About the mixer in 4-track mode
When the H4 is operating in 4-track mode, two
kinds of mixers can be used, namely the input
mixer and track mixer.
The input mixer takes up to two signals from the
built-in stereo mic or the [INPUT 1]/[INPUT 2]
jacks and sends them on in mixed form or
separately to the recorder tracks.
The track mixer adjusts the volume and panning/
balance of each signal recorded on the four
tracks and produces a stereo output signal.
Input 1
Input 2
[LINE OUTPUT] jack
Recorder
Track mixer
(for volume and panning)
Input
mixer
Track 1
Track 2
Track 3
Track 4
H4_E.book 47 ページ ２００６年９月１日 金曜日 午後７時５６分