User Guide

4-Track Mode
ZOOM H4
49
information on recommended settings, see page
32.
NOTE
Note that the signal input to the H4 will be
distorted if the input sensitivity is not set correctly.
3.
At the 4-track mode top screen,
press the bottom of the [MENU] key.
The INPUT menu for making various input
related settings appears.
4.
Move the jog dial up/down to bring
the cursor to "LEVEL". Then press
the jog dial.
The INPUT LEVEL screen for adjusting the
recording level appears.
HINT
• The alphanumeric indication at the left of the
signal level bars shows the input source ("1"
and "2" for the [INPUT 1]/[INPUT 2] jacks and
"L" and "R" for the built-in stereo mic).
• While this screen is being shown, the input
signal can be monitored via the [LINE OUTPUT]
jack and [PHONES] jack.
5.
When IN1&2 is selected, move the
jog dial up/down to bring the cursor
to the input source whose level you
want to adjust.
6.
Press the jog dial to bring up the
fader icon next to the meter display.
The recording level can now be adjusted. While
the fader icon is being shown, the cursor is not
shown.
7.
Move the jog dial up/down to adjust
the recording level.
The recording level setting can be checked on the
display. To record with optimum sound quality,
the input signal level should be set as high as
possible, without exceeding the 0 (dB) indication
on the meter. The setting range is 0 – 127. When
the recording level is too high, the sound will be
distorted.
HINT
• The recording level set here also influences the
signal level after effect processing. When
switching between effect on and off or when
changing effect settings, the recording level
may have to be readjusted.
• When effect processing is off, a recording level
setting of 100 will result in a unity gain (no
amplification) being sent to the track. If the level
meter indication shows that signal clipping
occurs, readjust the input source sensitivity
setting.
8. To terminate the recording level
setting, press the jog dial.
The recording level is set. The fader icon
disappears, and the cursor appears again.
If IN1&2 has been selected, repeat steps 5 – 8 for
Signal input
level
A
lphanumeric indication
of input source
Currently selected
input source
Recording level of source
selected with cursor
Fader icon
H4_E.book 49 ページ ２００６年９月１日 金曜日 午後７時５６分