User manual

Problem Possible cause Solution
The lamp is defective. Refer to "Replacing the lamp".
The compressor operates
continually.
The temperature is not set correctly. Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer than
necessary.
The product temperature is too high. Let the product temperature decrease
to room temperature before storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear plate
of the refrigerator.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
This is correct.
Water flows into the refrigera-
tor.
The water outlet is clogged. Clean the water outlet.
Products prevent that water flows in-
to the water collector.
Make sure that products do not touch
the rear plate.
Water flows on the ground. The melting water outlet does not
flow in the evaporative tray above
the compressor.
Attach the melting water outlet to the
evaporative tray.
The temperature in the appli-
ance is too low.
The temperature regulator is not set
correctly.
Set a higher temperature.
The temperature in the appli-
ance is too high.
The temperature regulator is not set
correctly.
Set a lower temperature.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
15