Specification Sheet

Model Z5615.272.00.00.00
1.28 gpf Elongated Wall Hung EcoVantage®
Hardwired Sensor Flush Valve Toilet System
Meets the American Disabilities Guidelines and ANSI A117.1
requirements when installed according to these require-
ments.
Fixture dimensions meet ANSI/ASME standard A112.19.2
and CAN/CSA B45 requirements.
In Canada - Consult local codes and standards.
All dimensions and specifications are subject to change without
notice.
Zurn Industries, LLC
5900 Elwin Buchanan Drive, Sanford, NC U.S.A. 27330 · Ph. 1-800-997-3876, Fax [phone]
In Canada
| Zurn Industries Limited
7900 Goreway Drive Unit 10, Brampton, Ontario L6T5W6 · Ph. 905-405-8272, Fax [phone]
www.zurn.com
Rev. -
Date: 10/26/2017
C.N. No. SAN007892
Prod. | Dwg. No. 317199
EcoVantage® is a registered trademark of Zurn Industries
TAG ____________
Z5615 Series Elongated (shown with seat)
This space is for Architectural/engineering Approval
Z5615 HET Series
• Zurn One HET Toilet System designed for optimal
performance between Zurn fixture and Zurn flush valve to
save water.
• 1.28 gpf (gallons per flush) [4.8 Lpf]
• 20% water savings over standard 1.6 gpf system [6.0 Lpf]
• Vitreous china
• Top Spud/Exposed System
• Hardwired Sensor Flush Valve Operation
• Elongated front rim
• 2-1/8" fully glazed trapway
• High efficiency siphon jet flush action
• Zurn product system component compatibility
and quality assurance
• Shipping Weight: 50 lbs.
Suffix Options:
 -RF Retro-Fit Nut Kit for extending carrier
studs from existing wall.
Recommended Carrier:
 Z1201 or Z1202 EZCarry
®
500 lbs load rated High
Efficiency Carrier
Recommended Trim:
 Z5955SS-EL Elongated, standard white,
open front toilet seat less cover with stainless steel
check hinge.
Note: To ensure system performance:
Minimum Running Water Pressure = 25 psi.
NOTE: MUST USE EITHER ZURN P6000-HW6 HARDWIRE POWER CON-
VERTER OR ZURN P6000-PC6 PLUG-IN POWER CONVERTER TO EN-
SURE PROPER OPERATION. USING A POWER CONVERTER OTHER THAN
ZURN MAY RESULT IN OPERATION MALFUNCTION OR UNIT FAILURE.
ORDER POWER CONVERTERS SEPARATE, AND ONE POWER CON-
VERTER OPERATES UP TO EIGHT VALVES.
Engineering Specification
Z5615.272 EcoVantage
®
High Efficiency Toilet System -
System comes complete with exposed ZEMS6000AV-HET-
IS, high efficiency sensor operated hardwired flushometer
valve, and vitreous china wall-hung toilet. The system is
designed to perform to industry standards with as little as
1.28 gallons per flush [4.8 Lpf]. Valve is exposed, quiet
diaphragm-type, chrome plated, flushometer valve with a
polished exterior, complete with Zurn’s AquaVantage
®
TPE,
chloramine resistant, dual seal diaphragm with clog-
resistant, filtered by-pass. The valve incorporates a
motorized actuator, an integral infrared convergence-type
proximity sensor, and a manual push-button override into an
all-metal, polished chrome plated housing. Sensor range
automatically adjusts to its environment at power up and is
powered by a 7.6 VDC power converter. This valve is
equipped with the ability to provide a 48 hour courtesy flush
if desired. Each power converter can accommodate up to
eight flush valves. The valve is complete with high back
pressure vacuum breaker, one piece hex coupling nut,
adjustable tailpiece, spud coupling and flange for top spud
connection. Control stop has internal siphon-guard
protection, vandal resistant stop cap, sweat solder kit, and
a cast wall flange with set screw. Internal seals are made of
chloramine resistant materials. Vitreous china toilet is 1-1/
2” top spud with 2-1/8” fully glazed trapway with siphon jet
action. Valve and toilet are an engineered system designed
to provide optimal performance and 20% water savings over
1.6 gpf [6.0 Lpf] conventional toilets.
This product should be used with a
WaterSense labeled counterpart with a
compatible flush volume to ensure that the
entire system meets the requirements for
water efficiency and performance.