User manual

Dish
Network
Remote
20
.1
IR
or
21
.0
IR:
These instructions describe how
to
configure your Dish
Network remote to
control
the
volume
from your
ZVOX Audio
system and not from your
TV.
The following
instructions
apply
to any TV brand except
Panasonic.
If
you have a Panasonic TV, use the alternate
instructions
below.
For
any
TV
brand
except
Panasonic:
Pa
rt
1: Config
ur
e
th
e
ZVOX
system
1. Power on your
ZVOX
system.
2. On
the
ZVOX
system front
panel, press and
hold
down both
MUTE and
VOLUME
UP
until PS-0
appears on the display
(about 5-6 seconds). Release
the buttons.
The
PS-0 display will
continue
flashing for about 5 seconds.
3.
While PS-0
is flashing,
repeatedly
press
VOLUME
UP
until
it
reads
"PS-5". Wait for the display
to stop flashing.
Part 2: C
onfigur
e
yo
ur
Di
sh
Ne
tw
o
rk
rem
ote
Program code to the
AUX
button
1.
On
the Dish
Network
remote
control,
press and
hold
the AUX
button until all
the other mode buttons
light
up, and then
release
the AUX button. The AUX button flashes.
2. Enter
0-5-1-2
then press the pound
key(#).
The AUX key
will blink three times.
Lock the volume buttons to the
ZVOX
1. Press and
hold
the AUX mode button
until all
mode buttons
light
up, then
release
it. The AUX mode button
will blink.
2 Press the
POUND(#)
button, press the
plus(+)
side
Of
the VOLUME
button, press the
0
number button,
press the
POUND
(#) button. The AUX mode button flashes
three times.
3. Press the
SAT
mode button then Press the
plus(+)
and
minus(-)
sides
of
the VOLUME
button down
simultaneously
and release
them.
You
have just
completed the programming. When
you press
VOLUME+,
VOLUME-,
or
MUTE, the volume
of
the
Sound
Base will
respond
regardless
of
which device button on
the Dish Network remote was
last
pressed.
20. 1
IR
above,
21.0
TR below
diSl?
•I
. _
.
..