User manual

Dish
Network
Remote
20.1
IR
or
21.0
IR:
FOR
PANASONIC
TVs:
Pa
rt
1: Co
nfigur
e
th
e
So
und
Base
sys
tem
1. Power on your
ZVOX
system.
2. On
the
ZVOX
system front
panel,
press and hold
down
both MUTE and VOLUME UP
until PS-0
appears on the
display
(about 5-6 seconds).
Release
the buttons.
The
PS-0 display
continues flashing for about 5 seconds.
3.
While PS-0
is flashing,
repeatedly
press VOLUME
UP
until
it reads
"
PS-3
".
Wait for the
display
to stop flashing.
Part 2:
Configur
e
your
Dish Ne
twork
remote
Program code to the
AUX
button
1.
On
the Dish Network remote
control,
press and
hold
the AUX button
until all
the other mode buttons
light up, and then
release
the AUX button.
The AUX button flashes.
2. Enter 0-8-5-8
then press the pound key (#).
The AUX key will blink
three times.
Lock the volume buttons to the
ZVOX
1.
Press and
hold
the AUX mode button
until all
mode buttons are
lit,
then
release
it. The AUX
mode button
will blink.
2. Press the
POUND(#)
button, press the plus (+) side
of
the VOLUME button, press the
0
number button,
press the
POUND
(#) button. The AUX mode button flashes
three times.
3. Press the
SAT
mode button, then press down the
plus(+)
and
minus(-)
sides
of
the VOLUME burton
simultaneously
and
release
them.
You
have just
completed
the programming. When
you press
VOLUME+,
VOLUME-,
or
MUTE,
the
volume
of
the
SoundBase will
respond
regardless
of
which device
button on the Dish Network remote was last
pressed.
20.
I
IR
above,
2
1.
0
IR
bel
ow