User manual

Comcast Custom DVR 3-Device Universal Remote Control
These instructions describe how to configure your Comcast cable remote
to control the volume from your ZVOX Audio system and not from your
TV .
The following instructions apply to any
TV brand except Panasonic.
If you have a Panasonic TV, use the alternate instructions below.
FOR ANY TV BRAND EXCEPT PANASONIC:
Part 1: Configure the ZVOX system
1. Power on your ZVOX system.
2.
On the ZVOX system front panel, press and hold down both
MUTE and VOLUME UP until PS-0 appears on the display
(about 5-6 seconds). Release the buttons.
The PS-0 display will continue flashing for about 5 seconds.
3. While PS-0 is flashing, repeatedly press VOLUME UP until
it reads "PS-5
". Wait for the display to stop flashing.
Part 2: Configure your Comcast remote
Activate the AUX function
1. On the Comcast remote control, press AUX once.
Then press and hold SETUP until the AUX key blinks
twice, then release Setup.
2. Enter 1-0-0-4-7. The AUX key will blink twice.
Assign ZVOX code to the Aux button
1. Press AUX once, then press and hold Setup until
the AUX key blinks twice, then release Setup.
2. Enter 1-0-2-5-0. The AUX key will blink twice.
Lock the volume buttons to the ZVOX
1. Press AUX once. Then, press and hold Setup until
the
AUX key blinks twice, then release Setup.
2. Enter
9- 9- 3 (the AUX key blinks twice) and then
press AUX once. The AUX key will blink twice.
3. Press the CABLE button once.
You have just completed the programming. Now, when
you press VOL+, VOL-, or Mute, the volume
of the ZVOX
system is controlled regardless
of whether the
Comcast remote is in the
TV mode or Cable mode.