ZyWALL User's Guide

Chapter 12 Policy and Static Routes
ZyWALL USG 100/200 Series User’s Guide
281
12.2.1 Policy Route Edit Screen
Click Network > Routing to open the Policy Route screen. Then click the Add or Edit icon
to open the Policy Route Edit screen. Use this screen to configure or edit a policy route.
See NAT Loopback Example on page 317 for an example of NAT loopback.
Figure 195 Network > Routing > Policy Route > Edit
The following table describes the labels in this screen.
Table 90 Network > Routing > Policy Route > Edit
LABEL DESCRIPTION
Configuration
Enable Select this to activate the policy.
Description Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Criteria
User Select a user name or user group from which the packets are sent. Select Create
Object to configure a new user account (see Section 35.2.1 on page 596 for
details).
Incoming
Interface
Click Change... to select an interface or VPN tunnel through which the incoming
packets are received.
Source Address Select a source IP address object or select Create Object to configure a new one.
Destination
Address
Select a destination IP address object or select Create Object to configure a new
one. If the next hop is a dynamic VPN tunnel and you enable Auto Destination
Address, the ZyWALL uses the local network of the peer router that initiated an
incoming dynamic IPSec tunnel as the destination address of the policy instead of
your configuration here.