ZyWALL User's Guide

Chapter 45 Logs
ZyWALL USG 100/200 Series User’s Guide
716
Figure 538 Maintenance > Log > View Log
Events that generate an alert (as well as a log message) display in red. Regular logs display in
black. The following table describes the labels in this screen.
Table 253 Maintenance > Log > View Log
LABEL DESCRIPTION
Show Filter /
Hide Filter
Click this button to show or hide the filter settings.
If the filter settings are hidden, the Display, Email Log Now, Refresh, and Clear
Log fields are available.
If the filter settings are shown, the Display, Priority, Source Address,
Destination Address, Service, Keyword, and Search fields are available.
No Filter These fields and buttons display when you hide the filter.
Display Select the log(s) you want to view. You can also view All Logs on one screen, or
you can view the Debug Log. The screen is updated right after you change the
selection.
Email Log
Now
Click this button to send the selected log message(s) to the Active e-mail
address(es) specified in the Send Log To field on the Log Settings page. (See
Section 45.4.1 on page 718 or Section 45.4.2 on page 719 for more information
about these fields.)
Refresh Click this button to update the information on the log screen.
Clear Log Click this button to clear the whole log, regardless of what is currently displayed on
the screen.
Filter These fields are displayed when you show the filter. When the filter is shown, the
filter criteria are not applied until you click the Search button.
Display Select the log message(s) you want to view. You can also view All Logs at one
time, or you can view the Debug Log.
Priority This field is read-only if the Category is Debug Log. Select the lowest-priority log
messages you would like to see. The log will display every log message with this
priority or higher. Choices are: any, emerg, alert, crit, error, warn, notice, and
info, from highest priority to lowest priority.
Source
Address
Type the IP address of the source of the incoming packet when the log message
was generated. Do not include the port in this filter.
Destination
Address
Type the IP address of the destination of the incoming packet when the log
message was generated. Do not include the port in this filter.
Service Select the service whose log messages you would like to see. The web
configurator uses the protocol and destination port number(s) of the service to
select which log messages you see.
Keyword Type a keyword to look for in the Message, Source, Destination and Note fields.
If a match is found in any field, the log message is displayed. You can use up to 63
alphanumeric characters and the underscore, as well as punctuation marks ()’ ,:;?!
+-*/= #$% @ ; the period, double quotes, and brackets are not allowed.