P-334WH 802.11g High Power Wireless Router Quick Start Guide

ENGLISH

Current screen information will be lost if you click Back.

STEP 1: System Information

STEP 2: Wireless LAN

Configure ONE of the following wireless security types on the P-334WH:

• Auto security: Have the P-334WH automatically generate a pre-shared key.

• None security: Have no wireless LAN security configured. If you do not enable any wireless security on your P-

334WH, your network is accessible to any wireless networking device that is within range.

• Basic security: WEP (Wired Equivalent Privacy) encrypts data frames before transmitting over the wireless net-

work. The higher the WEP Encryption, the higher the security but the slower the throughput.

• Extend (WPA-PSK or WPA2-PSK) security: Configure a Pre-Shared Key. Choose this option only if your wire-

less clients support WPA-PSK or WPA2-PSK respectively.

Note: The wireless clients and P-334WH must use the same SSID, channel ID and WPA(2)-PSK (if

WPA(2)-PSK is enabled) or WEP encryption key (if WEP is enabled) for wireless communication.

Auto or No Wireless Security

1 This screen is optional. You can just click Next.

• System Name is for identifying the P-334WH. You

can enter your computer's "Computer Name".

• If you leave the Domain Name blank, the domain

name obtained by DHCP from the ISP is used.

A Enter a unique name to identify the P-334WH in the wireless LAN.

B Select a wireless security level. Choose Auto or None.

C The P-334WH automatically scans for and selects a channel not in use by a nearby device. The P-334WH and

wireless client must use the same channel.

D If you select Auto and click Next, a screen pops up displaying the generated pre-shared key. Click OK to

continue. You can also view the generated pre-shared key in the Wireless LAN > General screen.