User's Guide

Chapter 17 System
NWA/WAC/WAX Series User’s Guide
184
The following table describes the labels in this screen.
17.3 Power Mode
Use this screen to configure the Zyxel Device’s power settings. Click Configuration > System > Power
Mode to open this screen.
Figure 107 Configuration > System > Power Mode
The following table describes the labels in this screen.
Table 80 Configuration > System > Host Name
LABEL DESCRIPTION
System Name Choose a descriptive name to identify your Zyxel Device device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
System Location Specify the name of the place where the Zyxel Device is located. You can enter up to 60
alphanumeric and '()’ ,:;?! +-*/= #$%@ characters. Spaces and underscores are allowed. The
name should start with a letter.
Domain Name Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes “-” are accepted.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 81 Configuration > System > Power Mode
LABEL DESCRIPTION
Force override
the power mode
to full power
Select this check box if you are using a PoE injector that does not support PoE negotiation.
Otherwise, the Zyxel Device cannot draw full power from the power sourcing equipment.
Enable this power mode to improve the Zyxel Device’s performance in this situation.
Note: Ensure that the power sourcing equipment can supply enough power to the
AP to avoid abnormal system reboots.
Note: Only enable this if you are using a passive PoE injector that is not IEEE 802.3at/bt
compliant but can still provide full power.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.