User's Guide

Chapter 17 System
NWA/WAC/WAX Series User’s Guide
200
Figure 120 SSH Example 2: Test
2 Enter “ssh –2 192.168.1.2”. This command forces your computer to connect to the Zyxel Device
using SSH version 1. If this is the first time you are connecting to the Zyxel Device using SSH, a message
displays prompting you to save the host information of the Zyxel Device. Type “yes” and press [ENTER].
Then enter the password to log in to the Zyxel Device.
Figure 121 SSH Example 2: Log in
3 The CLI screen displays next.
17.7 Telnet
You can use Telnet to access the Zyxel Device’s command line interface. Click Configuration > System >
TELNET to configure your Zyxel Device for remote Telnet access. Use this screen to enable or disable
Telnet and set the server port number.
Figure 122 Configuration > System > TELNET
The following table describes the labels in this screen.
$ telnet 192.168.1.2 22
Trying 192.168.1.2...
Connected to 192.168.1.2.
Escape character is '^]'.
SSH-1.5-1.0.0
$ ssh –2 192.168.1.2
The authenticity of host '192.168.1.2 (192.168.1.2)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.2' (RSA1) to the list of known hosts.
Administrator@192.168.1.2's password:
Table 86 Configuration > System > TELNET
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the Service Control table to access the Zyxel Device CLI using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.