User's Manual

Prestige 660R-6xC Series User’s Guide
179 Chapter 22 Filter Configuration
Figure 119 Menu 21.x.1 TCP/IP Filter Rule
The following table describes how to configure your TCP/IP filter rule.
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= No
IP Protocol= 0 IP Source Route= No
Destination: IP Addr=
IP Mask=
Port #=
Port # Comp= None
Source: IP Addr=
IP Mask=
Port #=
Port # Comp= None
TCP Estab= N/A
More= No Log= None
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Table 53 Menu 21.x.1 TCP/IP Filter Rule
FIELD DESCRIPTION
Filter # This is the filter set, filter rule coordinates, for instance, 2, 3 refers to the second filter
set and the third filter rule of that set.
Filter Type Use [SPACE BAR] and then [ENTER] to choose a rule. Parameters displayed for
each type will be different. Choices are TCP/IP Filter Rule or Generic Filter Rule.
Active Select Yes to activate or No to deactivate the filter rule.
IP Protocol This is the upper layer protocol, for example, TCP is 6, UDP is 17 and ICMP is 1.
The value must be between 0 and 255. A value of 0 matches ANY protocol.
IP Source Route IP Source Route is an optional header that dictates the route an IP packet takes
from its source to its destination. If Yes, the rule applies to any packet with an IP
source route. The majority of IP packets do not have source route.
Destination:
IP Addr Type the destination IP address of the packet you want to filter. This field is ignored
if it is 0.0.0.0.
IP Mask Type the IP mask to apply to the Destination: IP Addr field.
Port # Type the destination port of the packets you want to filter. The field range is 0 to
65535. A 0 field is ignored.
Port # Comp Select the comparison to apply to the destination port in the packet against the value
given in Destination: Port #. Choices are None, Less, Greater, Equal or Not
Equal.
Source:
IP Addr Type the source IP Address of the packet you want to filter. A 0.0.0.0 field is ignored.
IP Mask Type the IP mask to apply to the Source: IP Addr field.