User's Manual

Prestige 660R-6xC Series User’s Guide
185 Chapter 22 Filter Configuration
Figure 124 Menu 21.6.1 Sample Filter
Figure 125 Menu 21.6.1 Sample Filter Rules Summary
This shows you that you have configured and activated (A = Y) a TCP/IP filter rule (Type =
IP, Pr = 6) for destination telnet ports (DP = 23).
M = N means an action can be taken immediately. The action is to drop the packet (m = D) if
the action is matched and to forward the packet immediately (n = F) if the action is not
matched no matter whether there are more rules to be checked (there aren’t in this example).
After you have created the filter set, you must apply it.
1 Enter 11 in the main menu to display menu 11 and type the remote node number to edit.
2 Go to the Edit Filter Sets field, press [SPACE BAR] to choose Yes and press [ENTER].
3 This brings you to menu 11.5. Apply the example filter set (for example, filter set 3) in
this menu as shown in the next section.
Menu 21.6.1 - TCP/IP Filter Rule
Filter #: 6,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6 IP Source Route= No
Destination: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #= 23
Port # Comp= Equal
Source: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #=
Port # Comp= Equal
TCP Estab= No
More= No Log= None
Action Matched= Drop
Action Not Matched= Forward
Press ENTER to Confirm or ESC to Cancel:
Menu 21.1.6 - Filter Rules Summary
# A Type Filter Rules M m n
- - ---- ------------------------------------------------------------ - - -
1 Y IP Pr=6, SA=0.0.0.0, DA=0.0.0.0, DP=23 N D F
2 N
3 N
4 N
5 N
6 N
Enter Filter Rule Number (1-6) to Configure: 1