User Manual

4.Specifications:
Solar LED Light:
5.Troubleshooting
Most issues that arise can easily be resolved by
changing settings or reseting the driveway
alarms. Use the table below to find your exact
issue and possible solution for it.
Power supply : DC 4.5V ( 3 x AA batteries or by an adapter)
Wireless frequency : 433MHz±20KHz
Operating range：300m/1000ft (without obstacles)
Receiver’s ring volume：Over 100dB within 0.5m/1.6ft
Working temperature：-20°C ~ 50 °C
Solar panel: 5.0V 0.95W
Wireless frequency : 433MHz±20KHz
Li-ion battery: 3.7V 1800mAh
LED bead : 44 PCS white color led beads
Detecting distance: up to 6 meters
Detecting angle:120 degrees
Working temperature:-20-45℃
Waterproofing: IP 67
- 20 - - 21 -
Confirm that the receiver/
sensors are on. The receiver should
play a melody when the melody button
is pressed. Please make sure to turn on
the switch on the solar LED light before
use.
Issue Cause Solution
Follow instruction to pair the solar
light with the receiver.
The alarm
is not being
set off
Reset all sensors/solar lights
(see Manufacture default settings).
The working distance between solar light
and receiver is about 1000ft(300m). If the
solar light lights up when activated, but
no alarm plays on the receiver, then the
solar light is out of range. If there is heavy
interference between the solar light and
receiver, the maximum effective range
will be reduced. Move the solar light and
receiver closer together until alerts are
received consistently
Receiver /
Solar light
not powered
on
Solar light
not paired
with receiver
Incorrect
sensor
settings
Solar light
is out of
range of
receive /
Interference
issue