User Manual

Note:
1. Adjust the direction of the solar panel to face to
the sunlight so it is maximize the lighting effect.
2. Please install the sensor/solar LED light tightly
to ensure the position and the direction will
not be easy moved by wind.
After connecting the installation base with the
ground stake, stick the ground stake into the
ground.
- 12 - - 13 -
1. Use a pencil to mark the location of the two
mounting holes on the surface where the
installation base will be installed.
2. If installing on a wooden surface, only the
included screws need to be used. Drill out pilot
holes to help prevent stripping of the screws
and hold the sensor more securely.
3. If installing on any other surface, such as brick
or stone, use the included wall plugs with the
screws. To do this, drill out pilot holes, then
gently tap the wall plugs into the pilot holes
using a hammer until the wall plugs are flush
with the mounting surface.
4. Adjust the angle and tighten
the knob.
5. Install the base with the
screws onto the surface
and tight them. Make sure
not to over-tighten.
6. The PIR sensor detection angle is 120 degrees,
and the detection distance is 6 meters (20feet).
The suggested installation height is 2-2.2 meters
(6.5-7.2 feet).