User Manual
- 16 - - 17 -
SoluonIssue Cause
Inconsistent
alarms
The PIR sensor on which
transming frequency is 433MHz
and its range can be affected by
metal, concrete, and other
interfering signals from electronic
appliances with the same frequency.
Receivers or sensors mounted close
to siding or stucco may have
inconsistent signal recepon.
Avoid placing the PIR sensor and
receiver near the above menoned
materials and electronics.
Signal
interference
Low baeries can reduce a PIR
sensor’s working range. Replace
the sensor’s baeries.
Low power
supply in
the PIR
sensor
SoluonIssue Cause
The alarm
is not
being set
off
Follow instrucon to pair the PIR
sensor with the receiver.
PIR sensor
not paired
with receiver
Reset all sensors
(see Manufacture default sengs).
Incorrect
sensor
sengs
Reset all PIR sensor and pair them
again.
Inconsistent
alarms
PIR sensor
not paired
properly
The working distance between
sensor and receiver is about
1000 (300m). If the PIR sensor
acvated, but no alarm plays on
the receiver, then the PIR sensor
is out of range. If there is heavy
interference between PIR sensor
and receiver, if using in a heavily
wooded area, or signal passes
through mulple buildings, the
maximum effecve range will be
reduced.
Move the PIR sensor and receiver
closer together unl alerts are
received consistently.
PIR Sensor
is out of
range of
receive /
Interference
issue