Installation Instructions

4) Make wire connecons. Reference chart below for
correct connecons and wire accordingly.
Connect Black or Red
Supply Wire to:
Connect White Supply
Wire to:
Black White
*Parallel cord (round &
smooth)
*Parallel cord (square &
ridged)
Clear, Brown, Gold or
Black without Tracer
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other
than green) with copper
conductor
Insulated wire (other
than green) with silver
conductor
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth (See illus.)
Neutral Wire
5) Push xture to wall carefully passing mounng screws
with holes in canopy. Make sure all wires are inside
canopy and do not get pinched between wall and canopy
of xture.
6) Thread lockup knobs[E] onto mounng screws with
lockwashers[I] and ghten to secure xture to wall.
7) Slide down the wood frame[F] into the holder above the
socket on top of the washer.
8) Carefully slide the wood frame bracket[H] onto the
wood frame to secure into place.
9) Insert recommended bulb (Not supplied).
Fixture Diagram
Parts List
[A] Mounting
Strap
[B] Outlet Box
[C] Strap
Mounting
Screws
[D] Mounting
Screws
[E] Lockup Knobs
[F] Wood Frame
[G] Canopy
[H] Wood Frame
Bracket
[I] Lockwasher
Cauons
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starng and during the installaon.
WARNING:
This xture is intended for installaon in accordance
with the Naonal Electrical Code (NEC) and all local code
specicaons. If you are not familiar with code requirements,
installaon by a cered electrician is recommended.
Installaon Instrucons
E
A
C
B
G
D
F
H
I
1) Find the appropriate threaded holes on mounng
strap[A] that align with hole distance in canopy[G].
Thread mounng screws[D] into threaded holes starng
from outlet box[B] side.
2) Aach mounng strap to outlet box with strap mounng
screws[C]. The mounng strap can be adjusted to suit
posion of xture.
3) Grounding instrucons: (See Illus. a or b).
a) On xtures where mounng strap is provided with a
hole and two raised dimples, wrap ground wire from
outlet box around green ground screw, and thread
into hole.
b) On xtures where a cupped washer is provided,
aach ground wire from outlet box under cupped
washer and green ground screw, then thread into
mounng strap.
If xture is provided with ground wire, connect xture
ground wire to outlet box ground wire with wire
connector (Not provided) aer following the above steps.
Never connect ground wire to black or white power
supply wires.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
a
b
Installaon Instrucons (connued)