Installation Instructions

Smart Sensor

1loop-1.0

1.Press and hold the power button for 1.5 seconds,the middle

green LED light in on, it means turned on successfully.

2.Turn on the bluetooth and APP, select “my device”, and

connect the right sensor, then select”Start”, and after

overing the workout, select”End Exercise”.

3.Charging the sensor by USB charge cable(power voltage 5V 1A).

The middle LED shows different colors which represent as

following battery power rate: Red: 0-20%;Orange: 20-50%; Green:

more than 50%.(Note: charging voltage need to stable.)

After the sensor is disconnected from charging, connect to APP

to check the power percentage.

It takes about 1 hour from 0 battery to 100% full.

4.Different color LED lights means different range of tension

values, as follow:

1 green LEDs: 0.5-5kgs

2 green LEDs: 5-15kgs

PAGE 1
Smart Sensor 1loop-1.0 1.Press and hold the power button for 1.5 seconds,the middle green LED light in on, it means turned on successfully. 2.Turn on the bluetooth and APP, select “my device”, and connect the right sensor, then select”Start”, and after overing the workout, select”End Exercise”. 3.Charging the sensor by USB charge cable(power voltage 5V 1A). The middle LED shows different colors which represent as following battery power rate: Red: 0-20%;Orange: 20-50%; Green: more than 50%.
PAGE 2
3 orange LEDs: 15-30kgs 4 orange LEDs: 30-45kgs 5 red LEDs: 45kgs 5. Usage for reference: 6.Warning: Children under 5 years old are not recommended to play. If you want to use, please use it under adult guidance. FCC Warning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
PAGE 4
undesired operation. FCC The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.