Quick Start Guide

11 / 20
UNIT-TRIG This is where you set the hi-hat pedal’s response and
sensitivity. Set the main parameters (GAIN, THRES,
CURVE) to match your playing style.
The most important of these is GAIN. Set it so that only the
most forceful strikes produce a Level value of 0.0.
UNIT-HSET This page is used to set the hi-hat pedal’s sensitivity/level
(SENS) and its dynamic response (CURVE).
This completes the hi-hat settings!
6 Connections
This module provides the following inputs and outputs:
USB Use a commercially available USB cable to connect the module to
your computer.
12V DC This is where you connect the external power supply.
MIDI IN Connect this to the MIDI OUT socket on the external MIDI controller
to allow the module to receive MIDI messages.
MIDI OUT Connect this to the MIDI IN socket of the device that should receive
MIDI messages from the module.
Channels Connect your pads to the inputs that correspond to the instrument
you wish to trigger. The hi-hat controller needs to be connected to
the HIHAT B socket. The B channels of CYMB 1~3 are intended for
pads that accommodate 2 stereo cables.
Given that all inputs are balanced (stereo), be sure to only connect
stereo cables.