User's Manual

Saving Your Settings

TEMPO Here you can set the tempo. There is a tempo range from 30 to 280 bpm When you

press the rotary control while holding the MORE button, an arrow appears pointing to the

right → and you can set the tempo in steps of ten. Press the control once more ←, and

you can change the tempo in whole bpm steps again. The selected tempo can be saved,

of course, with each KIT.

Metronome sound

In the mode UNIT on the page METR you can select a sound for the metronome. It is a global

setting that applies to all KITs. See also page 57.

Functions for TYPE “Song”:

TIME Gives information on the duration of the song (the controller has no function).

FILE↓ Use the rotary control to select the desired song. The second display row shows the

name of the song (= filename). The number under FILE specifies the song position. All

WAV files on the module - regardless of their location - are listed in alphabetical order.

If the linked Song no longer exists because it was deleted from the module, a „?“ appears

under FILE instead of a number.

Split Wave-Mode

Press the DATA controller and hold MORE to go into the split-wave mode.

Now, next to the FILE number the symbols for song and metronome appear. In split

wave mode, the left and right signal of the song (WAV file) are automatically sent to

separate channels in the SUB-mix (see also page 55) In effect, this means for situation

1 (see figure below) that the left channel of the song is treated as a "metronome" and

the right channel as a "song". With Situation 2, it's the other way around.

Split-wave mode: Situation 1 Split-wave mode: Situation 2