User's Manual

UNIT Mode
41
9 UNIT Mode
In the mode UNIT you make general settings. On the pages in this section, you can change the general
routing and trigger settings, adjust the internal mixer and calibrate the hihat. The settings made here are
global and therefore apply to all KITS.
Changes in the mode UNIT are saved on the UNIT Main page (see SAVE on the next page).
9.1 UNIT – MIX
The DrumIt Three includes a mixer that allows you to balance out the volume levels of the drum channels.
There are eight FADER groups whose levels can be controlled individually.
LINE (L controls the line-in channel's signal and ACMP (A) controls, depending on the selection within the
kit, either the volume of the metronome or of the song player. The assignment of this group is fixed and
can not be changed.
The remaining six groups are used to control the volume levels of the drum channels. By default, the
respective channels are already assigned to the following groups: KICK (K), SNARE (S), HIHAT (H),
TOMS (T), CYMBS (C) and PERC (P). You can change the assignment of every channel individually on
the INTF page (see page 52).
View
The mixer page shows the three currently active FADERs - with full names. The "+" in the display „+ - -“
below FADER indicates which FADER group is currently selected. Again, you press the middle DATA
button to switch to the next group of three: You will notice that the "+" moves accordingly. To the right of
FADER a horizontal bar meter is depicted, which indicates the level of the output signal.
SAVE If you have made changes in the UNIT mode, this will be indicated by a „?“ next to SAVE.
To make these changes permanent, press the left DATA button. The „?“ disappears and
the changes are saved. Please be aware that for this the SAVE mode on the page PREF
has to be switched on (see page 59). Should the "?" still be there after you pressed the
DATA button, the SAVE mode is disabled.