User manual
11 / 20
5. Start the calibration process:
5.1. Press the leftmost DATA button once. A closed hi-hat icon appears in the
display and starts ashing.
5.2. Close the hi-hat pad or press the controller’s pedal with your foot.
5.3. Press the leftmost DATA button a second time. An open hi-hat icon
appears in the display and starts ashing.
5.4. Open the hi-hat pad or remove your foot from the pedal.
5.5. Press the leftmost DATA button yet again to exit the calibration function.
5.6. The display shows “done”. The hi-hat has been successfully calibrated. If
the message “NoChg” is displayed instead, the calibration could either not
be performed or was repeated with the exact same settings. If the cali-
bration routine failed, start by repeating steps 1~4 and then calibrate your
hi-hat again.
6. If the calibration was successful, you can now check whether the hi-hat responds
to your playing as expected. If you are not happy with the response, either repeat
the calibration steps or ne-tune the following parameters.
PFACT Increase this value to raise the calibration threshold. This is use-
ful for a consistent “foot chick” (pedaled hi-hat) and “foot splash”
(quick release of the pedal after a chick) sound. We recommend
taking your time to nd the setting that you are most comfortable
with.
POFF This parameter allows you to change the hi-hat’s calibration range:
higher values extend the range, while lower values narrow it
down. Bear in mind that changing this setting also aects the
PFACT setting. We recommend editing this parameter only once
you are thoroughly familiar with the system.