User manual

9 / 20
Rotate the knob to select the number of the KIT that should act as target for the
currently selected KIT. After specifying the new KIT number, you can select among
three functions: COPY, MOVE and SWAP.
Pressing the leftmost DATA button allows you to copy the selected KIT to the target
memory. MOVE allows you to move the KIT towards the target memory (the KITs
at and behind this position move one slot). SWAP, nally, causes the two selected
KITs to change places. In this example, KIT no. 1 moves to memory 80, while the
settings of KIT no. 80 move to memory location 1.
If you like, you can rename the settings during the COPY, MOVE or SWAP operation.
Saving Your UNIT Settings
When you change a setting in the UNIT menu, a “?” appears next to SAVE. Press
the leftmost DATA button to save the changes if you want to keep them. The “?”
disappears and your changes will be remembered. Please be aware that this is only
possible if SAVE mode on the PREF page has been switched on. If the “?” doesn’t
disappear after pressing the leftmost DATA button, the SAVE function is currently
disabled.