Advanced Manual

2. At the Installer Toolbox menu, tap System

Conﬁ guration.

Navigate to the System Conﬁ guration Menu

Program a Wireless Zone

The GC3 Panel lets you program a maximum of 100

wireless zones. To begin zone programming, navigate

to the Installer Toolbox. See “Navigate to the Installer

Toolbox” above. Then, tap System Conﬁ guration >

Wireless Zones.

NOTES:

When programming eSensors (Wireless & Keyfobs)

the equipment code must match the sensor being

installed. See page 68 for eSensor Equipment

Codes.

eSeries sensors are only compatible with the GC3e

panel.

Wireless Zones Menu

This reveals the Wireless Zones screen shown below.

Step 1: Select a Wireless Zone

First, select the wireless zone to edit.

1. On the left side of the Wireless Zones screen,

swipe up or down to move through the list of zones.

2. Tap one of the available zones to highlight it.

Pairing with a System

This feature allows the panel to pair with approved third-

party systems.

1. Navigate to the Installer Toolbox and tap System

Pairing.

Tap System - Pairing Mode

2. Press the

button to start the pairing process.

System Pairing - Enter Key

The system will listen for the pairing request from the third

party system.

Programming Sensors and Peripherals

Navigate to the System Conﬁ guration Menu

The System Conﬁ guration menu provides installers with

access to programming features for wireless zones, wired

zones, keyfobs, and keypads. It also provides installers

with access to panel programming options.

To navigate to the System Conﬁ guration menu:

1. Navigate to the Installer Toolbox. See “Navigate to

the Installer Toolbox.”