Advanced Manual

Program a Wired Zone

The GC3 Panel lets you program a maximum of two (2)

wired zones. To begin zone programming, navigate to the

Installer Toolbox. See “Navigate to the Installer Toolbox.”

Then, tap System Conﬁ guration > Wired Zones.

System Conﬁ guration > Wired Zones

This reveals the Wired Zones screen shown in step that

follows.

Step 1: Select a Wired Zone

First, select the wired zone to edit:

1. On the left side of the Wired Zones screen, review

the list of zones.

2. Tap one of the available zones to highlight it.

Note: A zone is available for programming when it

appears in gray text. A zone that has already been

programmed appears in black text.

3. Tap Edit Zone.

Wired Zones—Edit Zone Button

Step 2: Select a Sensor Type

Next, select the appropriate sensor type for the sensor or

peripheral being programmed.

1. At the Wired Zone <###> screen, highlight Sensor

Type.

2. Tap to expand the list.

3. Tap to select the appropriate sensor type from the

list.

Wired Zone <###>—Sensor Type

If you selected 04-Interior Follower, 06-24-Hour Silent

Alarm, 07- 24-Hour Audible Alarm, 08-24-Hour Auxiliary

Alarm, 10-Interior with Delay, or 23-No Response Type in

“Step 1: Select a Wired Zone” above, you must also select

the Sensor Equipment Type. If you selected a diﬀ erent

Sensor Type, skip this step and continue with “Step 3:

Choose the Equipment Age” below.

Tip: You can alternatively use the touchscreen

keypad to enter the two-digit code to select the

Sensor Type.

4. Tap ▼.

Step 3: Select a Smart Area Assignment

Select the Smart Area Assignment.

1. At the Wired Zone<###> screen, highlight Smart

Areas Assignment.

2. Under Smart Areas Assignment, choose the Smart

Area (Partition) for the zone.

3. Tap▼.

Wired Zone <###>—Choose Smart Area