Advanced Manual

Copyright © 2019 Nortek Security & Control LLC
85
6. Tap Edit Group to select the Group for the
association.
Z-Wave Association—Edit Group
7. Select the devices to be associated with the
controller device and tap .
Z-Wave Association Device
8. Tap to return to the Smart Home Settings
menu.
Note: Refer to device documentation for information
about the association groups supported by the
device.
Reset the Controller
You can reset the Z-Wave controller to remove all Z-Wave
devices from the network and to reset the controller to its
factory default state.
Note: Use this procedure only in the event that the
network primary controller is missing or otherwise
inoperable.
To reset the controller:
1. Navigate to the Smart Home Settings menu. See
“Navigate to the Smart Home Settings Menu.”
2. At the Smart Home Settings menu, tap Advanced
Settings.
Smart Home Settings—Advanced Settings
3. At the Advanced Settings menu, tap Reset
Controller.
Advanced Settings—Reset Controller
4. At the Reset the Z-Wave Controller screen, tap
Reset Controller.
Reset the Z-Wave Controller—Reset Controller
Note: Resetting the controller will delete all node
information from the GC3 Control Panel. Any