Advanced Manual

devices that were part of the mesh network will need

to be manually removed from the network before

they can be added to a network.

While the controller is being reset, the Working message

appears. Tap OK or wait a few seconds for the message to

close automatically.

Reset the Z-Wave Controller—Working

5. When the controller is reset, the following message

appears. Tap OK or wait a few seconds for the

message to close automatically.

Z-Wave Controller Reset Message

Learn Controller

The GC3 Panel can be added to an existing Z-Wave

network as a “secondary” controller (this process is also

called “copy” or “replication”).

When the GC3 Panel acts as a secondary controller,

devices can only be added to or removed from the Z-Wave

network at the primary controller. Other than that, all

functions are available to either controller.

To add the GC3 Panel as a secondary controller for an

existing Z-Wave network:

1. At the existing controller, add the GC3 Panel to the

Z-Wave network. (If the existing controller is a GC3

Panel, see “Add a New Device.” Otherwise, refer

to the documentation that came with the Z-Wave

controller.)

2. At the Home screen on the secondary GC3 Panel,

tap System Settings.

Home—System Settings

3. Enter the Master User Code to access the System

Settings screen.

4. At the System Settings menu, tap Smart Home

Settings.

System Settings—Smart Home Settings