Advanced Manual

5. At the Smart Home Settings menu, tap Advanced

Settings.

Smart Home Settings—Advanced Settings

6. At the Advanced Settings menu, tap Controller

Learn.

Advanced Settings—Controller Learn

The GC3 Panel displays a “Learning Z-Wave Controller”

message and waits for a signal from the primary controller.

The synchronization takes time, depending upon the

number of Z- Wave devices in the network.

Note: If a new Z-Wave device is added to the

network, the secondary controller must be re-

learned into the network.

Testing the Installation

Disable the Piezo Sounder

To disable the system’s sounder, navigate to the Installer

Toolbox. Then tap Disable Sounder. At the Sounder

Disabled message, tap OK. The sounder is disabled for 30

minutes (or until you tap the Re- enable Sounder button).

Perform a Walk Test

After installing the system, sensors, and peripherals,

perform a walk test to ensure proper console operations

and to test wireless reception and signal strength. To open

the Walk Test menu, navigate to the Installer Toolbox.

Then tap Walk Test.

To test wireless reception and signal strength,

tap Sensors Test. Then walk to and trigger each

sensor.

Walk Test—Sensors Test Screen

After you have tested all sensors, press .

To test the console operations, tap Console Test.

Then tap each button and respond Yes or No to

each question.

Walk Test—Console Test Screen

After you have tested all console functions,

press

Note: For compliance with ANSI/SIA CP-01-2010,

when you tap Sensors Test or Console Test, the

system sends a Walk Test Started message to the

Central Station. When you exit the test, the system

sends a Walk Test Terminated message to the

Central Station.